Problem 1: Fixed not solid or poorly installed Â
Solution: add rubber mat or foam, fixed and strong;
Problem 2: There are foreign objects on the blade, and the internal scale is too thick. Â
Solution: remove foreign matter and internal dirt on the blade;
Question 3: The eccentricity of the main shaft and the fan blade sleeve
 Solution: Re-adjust the spindle and the blade set to make it concentric
Problem 4: Motor bearing wear or bearing hole is too large  Â
Solution: Replace the new bearing of the same specification;
Problem 5: Partial short circuit or open circuit of motor winding
 Solution: replace the winding or motor;
Question 6: Improper assembly causes the blades to loosen and the wind frame to produce an abnormal sound
Solution: Re-assemble and tighten the blade tightly;
Question 7: Poor motor assembly Â
Solution: Correct the stator rotor gap of the motor to make it even, if the shaft is turbulent, add a suitable washer;
Question 8: Unbalanced wind blade deformation
 Solution: Correct the wind blade, adjust the dynamic and static balance of the wind blade;
Question 9: The design of the outlet pipe is unreasonable
Solution: The wind duct should be turned as little as possible, and the bend should be curved and round.
to sum up: This is the nine reasons for the vibration of the hood. If the camera shakes, if it is because of internal or installation problems, it is recommended that you look for after-sales maintenance. Do not do it yourself to avoid damage to the hood.
Zhejiang Osile Electric Co., Ltd. National Free Investment Hotline Address: No. 68, Weiyi Road, Chengdong Economic Development Zone, Zhangzhou City, Zhejiang Province
Column Load Cell,Fsr Sensor,Load Cell Forsentek,Impact Load Cell
Xiaogan Yueneng Electronic Technology Co., Ltd. , https://www.xyeloadcell.com